Is it possible to impose more thermal boundary conditions on the same surface?
Hello, I am new to CREO Simulate and I have just started to work on thermal simulations. I have a problem concerning boundary conditions for a steady state thermal analysis: in particular I cannot...
View ArticleClik here to view.
Re: Is it possible to impose more thermal boundary conditions on the same...
This seems like a pointless combination - it will just result in a heat loss through convection which is immediately compensated by the prescribed termperature, without affecting your model in any way....
View ArticleRe: Creo Simulate "Lost network license" while running non-linear analysis...
Hi Paul, We have confirmed that the license are being pulled from one License Server.This would be a good place to look for others facing the same issue.Still trying to get a copy of Creo 2 M080 to see...
View ArticleRe: Is it possible to impose more thermal boundary conditions on the same...
Ok, I've got the point. Thank you very much for the help!
View ArticleClik here to view.
Re: Creo Simulate "Lost network license" while running non-linear analysis...
Hi Don, please post your .psf-file: regardspaul
View ArticleClik here to view.
Re: Creo Simulate "Lost network license" while running non-linear analysis...
Hi Paul, Here's what I have in the simulate .psf file....We are pointing to two different servers but have verified that I'm only pulling a license from the main server and not the backup server.The...
View ArticleClik here to view.
Re: Creo Simulate "Lost network license" while running non-linear analysis...
yes, i think it's a problem: ENV=PTC_D_LICENSE_FILE-=7788@xxxxxx01.xxxxxx.com;7788@xxxxx04.xxxxxx.com You have 2 server.i have the same than i use 2 server, contact analysis too fe_clamp.zip regardspaul
View ArticleClik here to view.
Re: Design value for linearized stress results...?
Hi Mats,It's an old post, I hope you still follow the community.I think, the reason you didn't get any comprehensive answer is that Creo Simulate is not an ideal tool for pressure vessel engineering,...
View ArticleRe: Getting fasteners to work
Hi Sorry for the late answer. Attached is the assembly. I sent it to PTC and now there is the SPR 6759672 connected to this problem. As you will see there is nothing that violates any rule. The fact...
View ArticleClik here to view.
Re: Getting fasteners to work
Hello, model attached (corrected). You use a release >M100, better M080 regardspaul
View Article
