- I've already done the static analysis and I've not have problems with the mesh
PS: I use WF5 - I didn't know that. I'll take note. Thanks.
- I've done the analysis with "Fix separation" on Automatic; like in the picture.
Maybe I've done wrong...
"To avoid this, you will need a contact interface. If it doesn't matter, then leave as is, if you're not interested in fastener loads"
Which is the better method to simulate that link between the plates?
![Cattura.JPG]()
- Yes, I've tried but I've had some problems. Indeed I've opened another discussion (here) because there are some fasteners on the cut plane and. If you have some advice...
↧
Re: Exclusion of a component
↧