Re: how to find BELD Tension...???
There is no way to do this currently. The belt feature is nearly useless as a result. Please upvote my suggestion to add this capability: Tension Measurement for Belts
View ArticleRe: Is it possible to do Inertia relief analysis in Creo?
Did this post answer your question?
View ArticleClik here to view.
Assembly with only inherited parts and constraints
Hi! I am going to use Creo Simulate on an assembly model that contains parts that will change slightly during the design process but still not change in such ways that it will affect anything in the...
View ArticleClik here to view.
Re: Assembly with only inherited parts and constraints
If I understand the question correctly, I think you can do what you want with a family table in the assembly. (1) Set up the family table via the "Tools->Family Table", then add some instances via...
View ArticleClik here to view.
Mechanism problem
Hi Allim having a problem creating a mechanism. it consists of a worm driven gear mounted on a shaft, that turns a screw which should force a collar to travel linearly. i have the worm gear drive set...
View ArticleRe: Mechanism problem
You need a constraint that also keeps the cylinder from rotating, at least I'm assuming that's what is happening in the video. I'm assuming the slot on the tube has something that rides in it that...
View ArticleClik here to view.
Re: Mechanism problem
There are a number of ways to do this. I tend to make linkages between elements when I can but when I cannot, I drive additional servos.In this case, just make a generic gear connection between either...
View Articlein creo simulate, optiization design, can we obtain pressure (load) vs...
in creo simulate, optiization design, can we obtain pressure (load) vs displacement graph??
View ArticleClik here to view.
Re: Mechanism problem
Yes that is what im aiming for, sorry about the rubbish quality, it was the best way i could record it at the time. There is a key at the end of the tube that will ride along a channel in a housing, i...
View ArticleRe: in creo simulate, optiization design, can we obtain pressure (load) vs...
Thank You Paul.........
View ArticleClik here to view.
Re: Mechanism problem
It's been my experience you want to keep the references within the constraint sets elements to be to the same components or assemblies. Assuming the shaft axis is on the assembly fixed planes, I would...
View Articlehow to split symetrical model in ptc creo 3.0 for simulation?
I have a model but i want to split it in half, becase i would have then a half less finite elements. It is symetrical model. Can anyone help me?
View ArticleRe: how to split symetrical model in ptc creo 3.0 for simulation?
Hello,Blaz,Youcanlook atthislink,it isverycomprehensive.Kind regards.Denis https://www.ptcusercommunity.com/message/459991#459991
View ArticleClik here to view.
Re: how to split symetrical model in ptc creo 3.0 for simulation?
You may have a symmetrical model, but how is the model loaded for simulation?
View ArticleAnalysis on Assembly with compound materials
Hi I am trying to perform structural analysis on assembly consisting of parts with different materials, What will be the failure criteria on the resultant von mises stresses?
View ArticleRe: Specified rotational DOF in contact Analysis
You probably need to use a rigid (or weighted) link to connect the rotating point to your solid geometry.Enforced displacement, tangential direction, more than 1 revolution
View ArticleSurface region failed after model modification. Redefining not possible.
Dear All, A simulation has been run on a model, using surface regions. The sketches of the regions were made in the model (paramteric module) and they were the bases of the surface regions created in...
View Article