Clik here to view.
Re: Displacement in point out of 3D modeling
Ah - I think I remember now that it does this when you constrain a rigid link directly. Basically, it's saying that you've connected some geometry with a rigid link - but you've also constrained a...
View ArticleClik here to view.
Excessive displacement
Hello, I have a simulation including a stationary body and a moving body. There is a contact between them. I often see the warning: "Excessive displacement at contact region". A software suggests...
View ArticleClik here to view.
Re: ATB Operation don't allow
Hello Federico, Licence for ATB is required to export and update the files in Creo Parametric regards,Jignesh
View Article-results_io_cache_size
Hello,everyone!I find something newer in Creo 4.0 batch file".bat" than Pro/E 5.0,there is a parameter"-results_io_cache_size 1024",who can tell me how to set the value so that it will reduce the...
View ArticleClik here to view.
Re: Creo Simulate Multicore Calculation
Perhaps you disable "hyper threading" in bios,then everything will be ok.
View ArticleClik here to view.
Re: Excessive displacement
1.Refine the elements of the contact region and have a try,sometimes it's hard to converge for the solver when the elements are too large.2.Before it contacts each other,you can give less steps,then...
View ArticleClik here to view.
Re: Fasteners
I would suggest that "head and nut diameter" is on the outside of the two clamped components, determining where the bolt load is transferred to them; and "separation test diameter" operates where the...
View ArticleClik here to view.
Clik here to view.
How to calculate damped forces and stiffness within an assembly with...
Good Morning All I have been doing a project in Creo for the last few months and this is the first time I come across this software, I must say that this peice of software is just wonderful. I...
View ArticleRe: Excessive displacement
OK,thanks, I understand. My main problem is the "max 100 time steps". I have a quite long moving process and I should divide the full process to small steps but the 100 step possibility is not enough...
View ArticleRe: Excessive displacement
Roland, i recommend: MSC MARCcreo simulate ist not possible in this case regardspaul
View ArticleRe: Excessive displacement
Creo can do this large deformation analysis(below),so I think your question in not a problem.
View ArticleRe: Excessive displacement
Hi, his problem is plasticityandcontactandlarge deformation. regardspaul
View ArticleClik here to view.
Re: Fasteners: "cannot pair the linked assembly elements"
Hello!I have the same problemi I increase or decrease test diameter value (min.l 8 value), the mesh comand don't run with the same messagge in objectMaybe the problem is this?With the command "Review...
View ArticleClik here to view.
How to interpret output from a normalized input force-time curve.
Good Morning from Harbin Institute of Technology(HIT) of China, [[ I am a foreigner though ]] I am trying to understand how to interpret output from a normalized input force-time curve.My...
View ArticleClik here to view.
Re: Excessive displacement
My task is very similar to your 2. example (contact AND large deformation). But my model includes plasticity. As far as I see, the main problem is that the time step has to be small because the parts...
View ArticleClik here to view.
Re: Excessive displacement
Paul wrote "contact+plasticity+large deformation: not possible"Here's picture from a problem I ran a few years ago, with contact, plasticity and large deformation. You are restricted to using solid...
View ArticleClik here to view.
Re: Excessive displacement
Mats, i mean 2d of course: release: creo simulate 2.0 m080 regardspaul
View Article
