Clik here to view.
Re: Creo Simulate Multicore Calculation
Jonathan, no, it's not a bug, i thinkit's a workaround regardspaul
View ArticleClik here to view.
Clik here to view.
Re: Creo Simulate Multicore Calculation
Though we can't use multiple threading,but we can do these below to speed up:1.Disable "hyper threading" in bios;2.Put part of your RAM to use as RAM Disk;3.Put temp on the RAM Disk;4.Put the folders...
View ArticleClik here to view.
Re: How to use the FFT of Acceleration Data in Dynamic Frequency Analysis and...
Hi Caiming Wu, You may download my presentation about dynamic analysis here: Linear Dynamic System Analyses with Creo Simulate – Theory & Application Examples, Capabilities, Limitations It should...
View Article[Results]-Overlaying Fringe & isoline
Hello,Is there a way to overlay fringe results with isoline (Creo3)?I want to have a black line separation between my color spectrum.Thank you for any tipp
View ArticleClik here to view.
Re: [Results]-Overlaying Fringe & isoline
little workaround: export of plot as creo viewopen with creo view expressregardspaul
View ArticleRe: [Results]-Overlaying Fringe & isoline
Hello Paul,Thanks for your workaround, which I already knew it.I was wondering, if it was possible to do it direct within Creo environment.
View ArticleRe: Creo Simulate Multicore Calculation
We've just been testing M130 in response to a (non-Simulate) fatal error with a large model. Following this thread I tested an analysis (the same contact static I mentioned above) on my colleague's...
View ArticleClik here to view.
Clik here to view.
Clik here to view.
Re: Creo Simulate Multicore Calculation
CPU time is still 2x elapsed time so it can't be limited to a single core! Interesting, though, as it uses less CPU time total, but takes longer elapsed time to solve...
View ArticleRe: Creo Simulate Multicore Calculation
my pc has 4+4 cores. creo simulate 3.0 m130: 4 cores onlyold system: 4+4 cores, 20-25% faster regardspaul
View ArticleClik here to view.
Re: Creo Simulate Multicore Calculation
OK, so it looks like it's now only using n=physical cores instead of n=virtual cores. That explains both the decrease in CPU time and the increase in elapsed time - including the virtual cores is...
View ArticleRe: Creo Simulate Multicore Calculation
Jonathan, personally this doesn't worry me, i use creo 2.0 m080 for my professional work. regardspaul
View ArticleRe: ATB Operation don't allow
Hello,I have updated the model from Creo Modeling, only Good Life
View ArticleClik here to view.
Displacement in point out of 3D modeling
Hello!Supposing to have square with hole,I would like to fixe to the ground constraint at the middle of your lengthand at the center of the internal circumference (as show in image below) I thought...
View ArticleRe: Displacement in point out of 3D modeling
A small but significant point: this is a warning, not an error. You may still run your analysis with warnings. Can you share a screenshot of your complete model? It sounds like there is another...
View ArticleClik here to view.